[ixpmanager] peer-to-peer statistics | sFlow

[Nick Hilliard]

Vladislav Leontjev wrote on 22/03/2019 08:57:
> Sorry proccess was missed,
> Waited for sometime and here they are:

yeah, the --debug option outputs data every 60 seconds by default, so 
you won't see any output for one minute.

The configuration looks fine otherwise.

However, this does not look good:

> DEBUG: rejected: FLOW,10.81.7.25,17,0,0007ebea2860,00155d5c6135,0x0800,80,0,10.81.15.50,10.81.15.52,1,0x00,255,8,0,0x00,1522,110,8192

The bit that reads "0x0800,80,0," means that the frame is type 0x0800 
(i.e. ipv4), that the source VLAN is 80 and the destination VLAN is 0.

This doesn't make sense because you cannot have VLAN ID 0.  It happens 
because the switch isn't exporting sflowv5 Extended Flow Data, which is 
a known problem on some switching platforms.

Is this sflow data coming from a physical or a virtual switch?  If it's 
from a physical switch, could you run "sflowtool -p 6343 -4 -l" and post 
the output somewhere so that I can take a look at it?


Nick